1. Q2 Remotes – place two AAA batteries and insert the screw (optional) into the back of the remote.
  2. Q4, Q6 and QVOTE Remotes – place two AA batteries and insert the screw (optional) into the back of the remote.
  3. Q5 Remotes – plug the Q5RF participant and instructor remotes into the multi-charger and/or single charger for 24 hours
    before first use.
  4. Q7 Presenter Tablet – the tablet needs to be charged a full 24 hours for the first time or after a long period of inactivity. The pen may take slightly longer to fully charge. Generally, the tablet will only need to be charged about 6 hours to be fully charged after the initial charge. To charge the pen and tablet, place the pen into the pen tray located at the top of the Q7RF Tablet. Using the USB cable, plug the tablet into the computer. The battery icon will be full when the tablet is fully charged.Please Note: If your computer goes into power saving mode, the charging of the Q7RF Tablet may be interrupted.

 

Installing the HID (Black) Host/Receiver

USB HostSm

*This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

  1. The HID Host is located in the back compartment of the Q7RF Tablet or in the front pocket if remote bag.
  2. Plug the HID Host into an open USB port on the computer.
  3. The computer will automatically detect and configure the new hardware device.

 

Installing the RF (Red) Host/Receiver

RF Hostonly

  1. Plug the (red) RF host into an open USB port on the computer using the supplied
    USB cable.
  2. The computer will automatically detect and configure the new hardware device.