Hardware Setup

1. Q2 Remotes-place two AAA batteries and insert the screw (optional) into the back
   of the remote.
2. Q4, Q6 and QVOTE Remotes-place two AA batteries and insert the screw (optional) into the back
   of the remote.
3. Q5 Remotes-plug the Q5RF participant and instructor remotes into the multi-charger
   and/or single charger for 24 hours
   before first use.
4. Q7 Presenter Tablet-the tablet needs to be charged a full 24 hours for the first
   time or after a long period of inactivity. The pen may take slightly longer to fully
   charge. Generally, the tablet will only need to be charged about 6 hours to be fully
   charged after the initial charge. To charge the pen and tablet, place the pen into
   the pen tray located at the top of the Q7RF Tablet. Using the USB cable, plug the
   tablet into the computer. The battery icon will be full when the tablet is fully
   charged.

Please Note: If your computer goes into power saving mode, the charging of the Q7RF
Tablet may be interrupted.

Installing the HID (Black) Host

1. The HID Host is located in the back compartment of the Q7RF Tablet or in the front
   pocket if remote bag.
2. Plug the HID Host into an open USB port on the computer.
3. The computer will automatically detect and configure the new hardware device.

Installing the (Red) RF Host

We do not recommend using the red host with Qwizdom Mac Actionpoint or Mac Connect software. Email support at support@qwizdom.com for details.